After many discussions with Crown Automotive about the weaknesses in their water pump design they've come back with a revised model that uses an upgraded bearing. I have a handful of these new models in stock, but I would like to have a few more test pumps out there.

I've got a few testers already, but I'd like two more. If anyone is ready/willing/able just send me a PM.

_________________
2005 KJ CRD - EURO TC, GDE ECO-FT, GDE TRANS, Lift Pump(<- hard to install, worth it) = 32+ MPG highway and a great ride
Product & Catalog Director @ IDParts.com (888) 444-7951 sales@idparts.com http://www.idparts.com

Yup, still gonna pass.

_________________
http://www.Colorado4Wheel.com
"Its not about what you can DO with your Jeep, its about where you can GO with your Jeep."
Knowledgeable - But Caustic

Definitely going to pass. I don't plan on pulling the intake manifold and replacing $600 of broken rockers/lifters again.

_________________
05 Liberty CRD - Sold
07 WK CRD - Family SUV

Understandable, don't blame you at all. I've got a few positive responses, though.

_________________
2005 KJ CRD - EURO TC, GDE ECO-FT, GDE TRANS, Lift Pump(<- hard to install, worth it) = 32+ MPG highway and a great ride
Product & Catalog Director @ IDParts.com (888) 444-7951 sales@idparts.com http://www.idparts.com

Why not rig up an electric motor with a pulley and belt, and you can put a bunch of pumps all on the same drive for an extended test?

_________________
2006 LTD Bright Silver loaded with all the needed mods, CCV intact.
Proudly supporting CRD vendors, and their development of quality parts and accessories.
Equipped with HDS thermostat, plenty of heat, faster warm-ups, increased fuel mileage.