Who has bedliner'd their KK?

glsec507 · **Joined:** Mon Jul 18, 2011 4:12 pm **Posts:** 59

any pics, tips, suggestions? I want to do the floorboards......(on the inside)

cgass · **Posted:** Tue Aug 07, 2012 3:27 pm

I don't know of anyone who has done the inside of a KK. Digger did the whole outside. Gtommec just did his KJ. About halfway down the page here http://www.forbiddenjeeps.com/showthread.php/592-What-Have-You-Done-To-Your-KJ-Today/page2

glsec507 · **Joined:** Mon Jul 18, 2011 4:12 pm **Posts:** 59

Yea I've seen the pics of Diggers jeep but I wasthinking of using the do it yourself duplicolor bed armor or similar roll on stuff

DirtyKK · **Posted:** Tue Aug 07, 2012 4:30 pm

I've done my XJ in bed liner. DO NOT USE DUPLICOLOR or other cheap alternatives. They simply do not last. Use Raptor Liner or Monstaliner for DIY applications.

Roastbeef · **Joined:** Sun Jun 03, 2012 7:31 pm **Posts:** 199

DirtyKK wrote:

I've done my XJ in bed liner. DO NOT USE DUPLICOLOR or other cheap alternatives. They simply do not last. Use Raptor Liner or Monstaliner for DIY applications.

x2

i did my truck bed with duplicolor and it didnt even last 8 months.... that was sanding it down too

glsec507 · **Joined:** Mon Jul 18, 2011 4:12 pm **Posts:** 59

Anyone have experience with monstaliner or that raptor stuff?

Diggerfreek · **Posted:** Tue Aug 07, 2012 10:59 pm

You get what you pay for.

As far as tips, I know that the shop that did mine covered all of the rubber seals next to the windows with a silicone lubricant to prevent adhesion

CoopaTroopa · **Posted:** Wed Aug 08, 2012 8:28 am

Not to argue, but I did the lower half of my kj with dupilcolor spray on and it has been a year and a half through rain, snow, hail, and intense heat and it still hasn't faded or flaked. I spent A TON of time prepping by first degreasing then sanding, degrease, high number sanding again, then degreasing. Pretty much all of it needs to be scuffed very noticably for it to stick well. And make sure it isnt to humid or hot no matter what product you use.

At The Helm · **Posted:** Wed Aug 08, 2012 9:47 am

I have had much better results with that stuff using primer first. Holding the can about 18-20" away from the piece and doing very light coats is key. Its been on my steel front bumper for 5 months and no complaints other than being hard to clean. Still dont think i would use it on body panels though.

Who has bedliner'd their KK?

Who is online