52059410AB is the part # of just the hook. It is the same hook as Digger has. But the plate the hook is mounted on does not look correct for the KK. But it is hard to tell because the backside of the plate is hidden.
The hook "assembly" hook and plate has a different part #.
Here is a Pic I borrowed from Digger.

_________________
07 KA Light Khaki, Manual trany.
2.5" Adjust-A-Strut JBA lift, Euro taillights,
Home made; Front Tilt Hood, Roof Rack, RAM Air, & CAI.
ESP Off Switch
Take a ride on the Trō side!

So the m bolt does not require bumper removal? Are the m bolt hooks weaker?

No it doesn't but you'd be wasting your time and money while risking an injury or death. There have been few incidents of those pulling out. A 4 lb tow hook flying at 70mph can do some serious damage.

_________________
2010 KK 4WD BRILLIANT BLACK
Fox/King/Bilstein ATH BUMPERS ATH RACK GY DURATRACS

ATHFAB.com

More than a few. Don't forget the damage caused from pulling it through the plastic.

_________________
2010 KK Deep Water Blue,OME Liftplus 1",JBA 5.5 UCA ,Dynaflow cat back exhaust, Weathertech VV & mats,Mopar skids,Atthehelm front bumper, Smittybilt XRC 10, Rigid LED's,RL Skink Supersliders,Gecko Safari Basket Detroit Truetrac rear, E-Locker front, G2, Dana 4.10's