Going to replace my TB and WB later this week, and will not be taking out the CAC to do so. Wanting to see if my CAC has any leaks, I made a test cap for each hose (one with an air pressure gauge in it and one with an adaptor to hook up to an air compressor) to pressurize the CAC. I'll then remove it if needed while doing the TB/WP.

What is the max pressure I should take the CAC up to to check for leaks?

Thanks,

Steve

I get up to 22 psi driving my jeep acording to my boost gauge. So 25 PSI should be enough.

_________________
Phil
2005 131k 3.7 Gasser (Lifted-CRD Springs, 4.10 Gears, F+R DTT, Teraflex 2wd Low, Skidrow/Mopar Skids, Rock Lizard Super Skinks, Goodyear Wrangler Authority 31x10.5-15)
2012 Triumph Tiger (TKC 80 Front Tire Heidnau K60 Rear, Crash Bars, Skid Plate, Bark Busters, Pelican Case Top Box)