I can't seem to find the answer anywhere but what are the corresponding cylinder numbers on the CRD? Specifically, the cylinder number against the fire wall? Also, What is the process on replacing an injector as I know they are codded for their specific cylinder. Thanks!

Ken

_________________
2006 CRD
2.5 Frankenlift,ARB front bumper with internal winch.snorkel soon to have rock lizard bumper, sliders and roof rails, 2nd gen filter head
GDE eco tune-need trans upgrade and new TC
Beaverton Oregon

1 in the front of the engine 4 next to the firewall.. Injectors are easy.. Unplug.. One bolt holding it in and the hard line nut.. The bolt is a 10 mm the hard line is a 17mm (i think... Maybe a 14mm)

Sent from my SCH-I535 using Tapatalk

_________________
Trevor

'05 Limited CRD Inferno Red Pearl Coat
Home made provent installed @ 35443, SEGR installed @ 35466, Fumoto valve @ 37500, trans and transfer case skid, In tank pump installed @ 43500, Suncoast TC & Transgo Shift Kit @ 44730, EGT, Boost, Trans temp gauges, Samco hoses, Rebuilt Trans w/ HD454RFE kit @ 56K, Inmotion Stage 2 @ 56K

There is also a label with the injector number, on the injector wire, if it's not torn up.

_________________
2005 kj CRD, samco, suncoast tc, provent, Kennedy lift pump, GDE ECO full torque, 2nd gen filter head, 245/70/16 a/t tires, mopar light bar, fumoto oil valve, OEM Skid Plates, ARB Front bumper and HD OME, tru cool LPD47391 40k GVW tranny cooler (stock cooler delete), FF Dynamics e-fan and shroud, rocker arms replaced, HDS2 190F thermostat.

Is there a schematic that shows the firing order? I go Googled it, without much luck...Thanks!

_________________
2006 CRD
2.5 Frankenlift,ARB front bumper with internal winch.snorkel soon to have rock lizard bumper, sliders and roof rails, 2nd gen filter head
GDE eco tune-need trans upgrade and new TC
Beaverton Oregon

FSM (download from Sir Sam's Noob guide link) says injection order is 1-3-4-2 which I presume is firing order.

_________________
Sold to LOST member my 05 Ltd, GDE Stg II turbo + TCM tune, SunCoast TC w. Transgo kit, Steiger window regulators, Samcos, Fumoto valve, 2nd gen filter head with Lub. Spec. bleeder, Hayden clutch & 11 blade fan, inverted spare, P-1 battery, BF Goodrich Long Trail TAs, Etecno1 glow plugs, timing belt at 50K miles/8 yrs

Correct, and most 4 cyl engines I've seen have the same order, 1-3-4-2, I'd guess is because of better balancing of the engine.

_________________
2005 kj CRD, samco, suncoast tc, provent, Kennedy lift pump, GDE ECO full torque, 2nd gen filter head, 245/70/16 a/t tires, mopar light bar, fumoto oil valve, OEM Skid Plates, ARB Front bumper and HD OME, tru cool LPD47391 40k GVW tranny cooler (stock cooler delete), FF Dynamics e-fan and shroud, rocker arms replaced, HDS2 190F thermostat.