When doing the injector return flow test, at idle, how fast should the bottles be filling?
Because I just did this test and it was barely a trickle. Although all four injects seemed about the same with #2 being slightly more than the others.

_________________
U.S. Army Retired

A slow trickle is right, I never used bottles so I can't give you good measurements though. I think the main thing is that they are close to the same. I think there's a spec for how close they should be.

_________________
05 CRD: H.D.S2 stat,WW Ironrock trilink&LCA's, OX rear,ARB front, 4.10's, ARB bumper, Suncoast,OME 3.5, JBA UCA,rock rails, Moabs&265/75 Duratracs, GDE tunes ,FFD fan,ARP's, 2 micron fuel, new valves,sasquatch battery tray & grid heater, tensioner relocated
Mech fan, VH & AC delete

good ,injector are ok

Take a look at this leak off test.

http://sprinter-source.com/forum/showthread.php?t=17149

_________________
2006 LTD Bright Silver loaded with all the needed mods, CCV intact.
Proudly supporting CRD vendors, and their development of quality parts and accessories.
Equipped with HDS thermostat, plenty of heat, faster warm-ups, increased fuel mileage.