Does anyone know the thread size for the cam pin plugs in the valve cover. Ended up loosing one doing the timing belt change and can't find a part number for it on any of the Mopar sites.

I have no clue.
But you may be able to take the other plug to a hardware store, find a small bolt that is the same thread size, cut it shorter if you have to, and seal the threads with some blue locktite or nail polish.
It doesn't have to be in there tight. It just has to keep oil from leaking out.

_________________
U.S. Army Retired

Here is a source, just need to figure out what size it is.

http://www.zoro.com/parker-hollow-hex-plug-m10-x-1-metric-vsti10x1edcf/i/G5007581/?gclid=CNHZzPq7ocgCFeOD2wodR0AJ9w&gclsrc=aw.ds

_________________
2005 CRD "Ol' Blue"
Red Ryder carbine-action, two hundred shot range model air rifle with a compass in the stock and this thing which tells time.
My build page- RL Komodo Rear and TJM Front Bumper, armored, lifted, JBA Steel D30, 4.10s and ARB air lockers.

Mopar part number: 05066787AA

_________________
'06 Liberty CRD Limited. Bought at 91K miles.
ARP studs, New rockers, Stant inline tstat, Weeks 1&2, Provent, IDParts Silicone hoses,
2-1/2" Full OME lift, Timing belt, Water pump, TransGo kit, Plastic fan, Fumoto
2nd gen fuel head with 2nd stage 2 micron filter, in-tank lift pump, G2 Rear Diff Cover

They're M10x1

_________________
Share your ideas freely at https://www.facebook.com/groups/libertydiesels/