foxhunter wrote:
maybe pb spray or heating the engine to max temperature?
X2 on both.
Soak it good with Kano Kroil Penetrating Oil or PB Blaster.
tighten it back up, heat engine up either by running or plugging in block heater. Running will get you more temperature.
While engine is still up to temperature,
soak it some more, then break it loose again,
then spray head of GP real good with CRC 05002 Freeze-Off Super Penetrant.
The freeze-off will actually help make the GP metal contract slightly to help ease extraction.
then slowly work it back and forth in short turns while continuing to spray it with freeze off while working it to fully out.
Keep your fingers crossed!
Best of luck...
_________________
Supporting Vendor and Moderator of LOST05 Jeep Liberty CRD Limited
Ironman Springs/Bilstein/Shocks
Yeti StgIV Hot Tune
Week's BatteryTray
No FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pmp
2mic.Sec.Fuel Filter
Flowmaster/NO CAT
V6Airbox/noVH
GM11 Bld.fan/HDClutch
IronrockArms/wwdieselMount98 Dodge Cummins 24 Valve