rankom wrote:
im not pulling wrenches for living any more , but i do remember when i did engine overhauls , say like front seal on cummins 5.9 or similar , front seal usually comes packaged with plastic sleeve inside so would go over crankshaft without damage ,then you drive seal inward with tool of your choice , and that plastic sleeve is no longer needed , CAT engines was same , so lip must be installed in and only dust lip is visible outside , dont know how crd seal looks like so , can you post picture of this seal and , does it come with this instalation plastic sleeve like i describe , if it doesnt , then it will be tricky to install without damage to the seal
No it does not come with a sleeve. I'm fairly new here not sure how to post photos I will if I can figure that out