mr.jerryfluffy wrote:
Hello! I’ve been researching crd lifts for a little bit and the general agreement is don’t go over 2.5 inches unless you have deep pockets right? I don’t really know much but would a subframe drop allow for a bigger lift even on crd models? They don’t seem too expensive. anyone’s .02¢ would be appreciated.
If you want to go higher than 2.5" lift or maybe 3" max, it may be time to consider a SFA conversion. It may be better suited and much stronger than trying to simply drop the engine cradle.
_________________
Supporting Vendor and Moderator of LOST05 Jeep Liberty CRD Limited
Ironman Springs/Bilstein/Shocks
Yeti StgIV Hot Tune
Week's BatteryTray
No FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pmp
2mic.Sec.Fuel Filter
Flowmaster/NO CAT
V6Airbox/noVH
GM11 Bld.fan/HDClutch
IronrockArms/wwdieselMount98 Dodge Cummins 24 Valve