atunicus wrote:
Resurrecting this old thread.
I still have not been able to get my jeep to start. I have recently replaced the crank position sensor and that did not help.
I also bled the fuel system again, fuel head and injector number 4. I do not seem have any air stuck anywhere.
At this time I only get one error code which is P0304 and I do not believe it is related to the non start condition.
I really wish this vehicle would provide some sort of code to push me down another direction of troubleshooting.
Need a little more info.
You say it does not start. So does the engine spin over ok when you turn the key to start/crank position, you did not say?
If it
does not spin over when you turn the key to start/crank, it is a whole different set of checks.
If the engine spins over ok when you turn the key to the start/crank position but does not start, that is a different set of checks.
Do you have any red lights on the dash like the security warning lamp staying on as that can prevent starting.
Got to figure out why it is not getting fuel, is it due to a fuel (pressure, starvation, air in fuel) related problem or an electrical problem, wiring, sensor etc...; then you can narrow in your testing and troubleshooting.
There is a host of things to check and rule out depending on what is taking place...
_________________
Supporting Vendor and Moderator of LOST05 Jeep Liberty CRD Limited
Ironman Springs/Bilstein/Shocks
Yeti StgIV Hot Tune
Week's BatteryTray
No FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pmp
2mic.Sec.Fuel Filter
Flowmaster/NO CAT
V6Airbox/noVH
GM11 Bld.fan/HDClutch
IronrockArms/wwdieselMount98 Dodge Cummins 24 Valve