This is posted somewhere, but this is eaiser than searching.

Whats the size of the black plastic pop rivets holding the fenders on?

_________________
2008 Xterra 4x4

1986 CJ7
Lots of custom stuff...

Gone, But not Forgotten...
2003 Sport - 'Fire Engine' Red
Detours KJ Backbone
Skids
Boulder Bars
JBA 4.5 A Arms
245/75/16 Wrangler Duratracs's on Cragar Soft 8’s
Spidertrax 1.25" Spacers
Superwinch LP 8500
Frankenlifted

Read through this thread. It should help out.

http://www.lostjeeps.com/forum/phpBB3/vie ... php?t=4797

I just searched for "flare rivets" and scanned the results for something that looked like it would answer your question. Hope this helps.

Cheers

_________________
'04 Liberty Sport
OME HD and clevis lift
245/75/R16 MTRs
ARB bumper with Daylighters and warn 8000lb winch
Trail rash
Switches, lots of switches
Urban Dirt Offroad member www.urbandirtoffroad.com

napa part #770-2871

Part number directly off the package. I did have to wait a day for those to be delivered from the warehouse

_________________
'04 KJ Sport
Mods - Mopar side bars, 4 window regulators. What, windows aren't mods? Maybe I could spend money on cooler stuff if they'd stop breaking!!!! =P

Just an FYI....you don't need a rivet gun for them. Not sure if you knew that, but your post sounds like you might be trying to find a rivet gun for their size.

Just trying to be helpful in case you weren't aware.

_________________
===
New KJ Gear - Desert Armor Flak

2004 Renegade Light Khaki - 4" JBA Lift - Rock Lizard Products: Komodo Dragon Rear Bumper, Prototype Winch-mount Front Bumper, Super Skink Sliders - All J's Super Tranny Skid II - 31" Firestone Destination AT's on Moab wheels - Cobra 75W CB w/ stock Antenna mod

[b]Retired, US Military