To early to tell, only put 25 miles on it so far, getting ready to go back out and drive for some more miles, need to get that 500 mile break in done.

_________________
Will
05 Limited 4x4 Franky II Al's A-arms Black Moabs with MTR's Remote Start SOLD
06 TJ Rubicon Built
06 Dodge 2500 Diesel - Tow Pig
89 Wrangler not much left stock on it

any feedback guys, improvements in fuel economy , drivability


lots of questions need answered

oh

Yukon Gears are they any good ?

_________________
http://www.cardomain.com/memberpage/742957
aussie KJ Lost No#150605
3" OME lift + Rancho RS9000xl's front and rear
prototype Airflow snorkel
Magnaflow cat back
265/70R16 Hankook MTRT03 on MOABS baby
4.10's and a truetrac up front
super skinks
coming soon
a myride wireless controller

OK so when lads have fitted the DTT to the front, have they come across a problem with the hemispheres not having the grooves for the driveshaft retaining clip to sit in.. As thats what I have been told by the guys fitting the DTT to the front of my KJ, and they have to disassemble the carrier and machine the grooves..

I've looked at it myself, and you can clearly see the grooves in the standard diff centre, and they are not there in the DTT....


Any thoughts?????????

_________________
SOME SAY

I'm Toight... Toight lik a Toiger.

And

When I go to the Toilet, Chuck Norris is there to tear the squares off for me.

"Pass me another one Chuck, and keep em coming!! On sencond thoughts..Go get the hose"

Mine is completed.

I changed my fluid the other day and found some metal shavings expected with new gears and the lockers.

Mileage improvments 1.5 per gallon, my speedo and tachometer are still off.

Have not had a chance to test the lockers and of April when I go to Rausch Creek.

For the front the guys that replaced had no issues, the rear yoke had to be ground down to fit but nothing was said about the front.

_________________
Will
05 Limited 4x4 Franky II Al's A-arms Black Moabs with MTR's Remote Start SOLD
06 TJ Rubicon Built
06 Dodge 2500 Diesel - Tow Pig
89 Wrangler not much left stock on it

No issues when I installed my DTT in the D30A,the CV's will stay put and no machining required.

Mine go in on Monday.. so I will post as well when said and done...

_________________
2016 JKU RUBICON

other mods coming soon...

Hmmm, I thought that myself, but, this guy doing the work is good and honest, so I do trust him, main issue was not so much getting them in, it's the getting the shafts back out, if the clip expands and locks the shaft in there, or gets pulled off the end of the driveshaft when you remove it and leaves the clip in the diff centre......


Will see what happens.

_________________
SOME SAY

I'm Toight... Toight lik a Toiger.

And

When I go to the Toilet, Chuck Norris is there to tear the squares off for me.

"Pass me another one Chuck, and keep em coming!! On sencond thoughts..Go get the hose"