What is the best/cheapest way to get a tranny skid plate for my 03 Renny? I already have all the rest, but would like to cover that big, vulnerable tranny pan before it finds a can opener. Not too bad a problem in Florida, but we are headed back out West this Summer and I would like to keep the tranny pan in one piece.

_________________
Jim

2003 Liberty Renegade
Leather Electric Seats
Self-Dimming Mirrors
Sun Roof
MOPAR Rock Rails, Skids, Rear Hitch
EMU Heavy Duty shocks and Springs 2.5" lift
Front Tow Bar (for RV)
Firestone 255 70 16 Destination AT Tires
Straps and Chains

one of the newer model ie: 05 tranny skids will work, just have to beat part of the upper side of it flat with a big hammer so that it clears the exhaust on the drivers side, and drill a different hole in the skid so that it lines up with pre-existing holes on the trailing side

the front side will sandwich just fine between the engine skid and the cross member

_________________
03 Renegade (Black)
177k miles 3.7L gas - 45RFE
Command Trac / 4.10s
Lift: ft. 790+ rr. JBA4+
The last of the TrailReady Front&Rear Bumpers and TR Rock Rails
Jarhead Offroad light covers
31x10.5R15 RedLetter Grabbers on Blackrock Dunes
L.O.S.T #KD098632

Do you know if there is a "How To" somewhere on the Lost site?

_________________
Jim

2003 Liberty Renegade
Leather Electric Seats
Self-Dimming Mirrors
Sun Roof
MOPAR Rock Rails, Skids, Rear Hitch
EMU Heavy Duty shocks and Springs 2.5" lift
Front Tow Bar (for RV)
Firestone 255 70 16 Destination AT Tires
Straps and Chains

It is actually pretty self explanitory once you have the skid in hand. You will see the spot that you need to beat with the hammer.

_________________