tommudd wrote:
Not at all hard to do
and yes much safer / easier to take them to a shop to have the front springs / shocks put together
I can't emphasize this piece of good advice enough. When I did my 2.5" Daystar lift a couple weeks ago I first took Tom's advice with a grain of salt and attempted to compress my front springs with a good heavy duty set of screw type compressors, and with the springs at about half compression the tool looked like it was going to fly apart on me.
I ended up taking Tom's advice and took my fronts to a local garage to use their floor press, and even then I had to get the assembly in their machine just right so it wouldn't fly out on me.....
Other than that it's not a difficult job, took me approximately 6 hours total....