I bought the factory light bar to install on my 05 lib could someone tell me what size an type of nutsert i need ? A pic would be great. Thanks

_________________
2005 jeep liberty CRD GDE Full Torque Eco tune,Blue Samcos,Transgo shiftkit,Provent,V6 Airbox, Facet 40109 fuel pump ,Straight piped . OME lift 235/75/16 Hankook DynaPro ATM tires,weeks101 elbow kit FCV/EGR delete

everything needed to know about installing one right here

http://www.ifsjeepers.com/phpBB3/viewtopic.php?f=24&t=38

at the same time i should know this because i just installed one on my WJ a little over a month and a half ago

_________________
With enough fabbing, time & $, it's certainly possible.
That being said, it's like boinkin' your sister...just because you can, doesn't mean you should.

also you can never use enough RTV on your drilled holes in the roof

_________________
With enough fabbing, time & $, it's certainly possible.
That being said, it's like boinkin' your sister...just because you can, doesn't mean you should.

Thank you very much

_________________
2005 jeep liberty CRD GDE Full Torque Eco tune,Blue Samcos,Transgo shiftkit,Provent,V6 Airbox, Facet 40109 fuel pump ,Straight piped . OME lift 235/75/16 Hankook DynaPro ATM tires,weeks101 elbow kit FCV/EGR delete

I'd like to suggest that you use polyurethane windshield sealant. you won't use much, but it will seal perfectly and never have an issue. You would do well to put sealant over the hole before inserting the nutcert and clamping it down, then using it again when you run the bolts in.

When I did this, I put two bolts in from underneath with sealant to hang it by, and it would have been ideal to do this on all in case I ever need to remove it.

that is what i did when i installed one on my WJ

_________________
With enough fabbing, time & $, it's certainly possible.
That being said, it's like boinkin' your sister...just because you can, doesn't mean you should.

Did you just seal bolt holes ? does the base of the light bar need any sealant where it contacts the roof?

_________________
2005 jeep liberty CRD GDE Full Torque Eco tune,Blue Samcos,Transgo shiftkit,Provent,V6 Airbox, Facet 40109 fuel pump ,Straight piped . OME lift 235/75/16 Hankook DynaPro ATM tires,weeks101 elbow kit FCV/EGR delete

i used sealant on the nutcert's and the on bolt holes before i screwed then in and the hole where the wiring gromit is at. there is no need to put sealant on between the roof and light bar

_________________
With enough fabbing, time & $, it's certainly possible.
That being said, it's like boinkin' your sister...just because you can, doesn't mean you should.

What he said.

Thanks again

_________________
2005 jeep liberty CRD GDE Full Torque Eco tune,Blue Samcos,Transgo shiftkit,Provent,V6 Airbox, Facet 40109 fuel pump ,Straight piped . OME lift 235/75/16 Hankook DynaPro ATM tires,weeks101 elbow kit FCV/EGR delete