MrMopar64 wrote:
Synchronization errors can be caused by a variety of reasons:
*Faulty cam sensor
*Faulty crank sensor
*Damaged tone wheel on crankshaft
*Bad wiring in vehicle
*Engine is out of synch and needs to be re-timed
The misfiring and not running well is likely a product of the lack of synchronization and/or faulty crankshaft speed signal. I've seen both of these cause your problems (crappy running w/o CEL), unfortunately they're not always easy to fix. I would bet a wiring issue and/or ECU problem if it does it more when warm vs. cold. Where are you located?
Sound like the Air Flow Valve(flapper) is not openinig.
Take the cac out and tell somebody to crank the CRD and check the flap, if it stay close or it closes after it start and it goes off, that is your ploblem.
also the sensor that is back on the right side,(pasenger side) that is the sensor that keep the #1 piston in time if that sensor can not see the #1 piston it will never crank but also when is cold it will crank and when get hot and you turn off the engine, it will never start up again, until it get cold.