Are there any dyno curves available with the various tunes that are available....GDE, Inmotion, etc.?

I see numbers claiming HP and torque improvemts but never any dynos that show the real curves over the rpm band.

All numbers are an average of three runs, each, but they were so close that averaging really wasn't needed.

All runs were done on a Dynojet chassis dyno in Drive with OD off.

We got peak power of 168.3HP @ 3500 and 307.8 lb/ft @ 2500 with the GDE ECU.

Then I installed the InMotion and did three runs.

We got 180.8 HP @ 3500 and 328.7 lb/ft @ 2530

This was an increase of 10 HP and 25 lb/ft with the IM ECU over the runs I made a year ago on the same dyno, comparing the stock ECU with InMotion, The CAT "clean", new exhaust, SEGR and lift pump may account for the improvement. (At the time, the stock ECU put out 144.6 HP and 250.6 lb/ft.)