SO EXCITED!!!

Jeepjeepster · **Posted:** Thu Aug 03, 2006 1:38 pm

Bullet wrote:

I will call Heather because I ordered the Frankenlift with the OME stut assembely. There are Ranchos in the rear tho....better to ask first than wonder later....lol.

Just to give you a heads up bullet. With the OME front struts, it seems to be a bit bouncy when pulling or slowing to a stop. If you are pulling into a parking spot or something and dont take it easy on the brakes, it may get alittle crazy. They ride great on the HW though, much better than the stock shocks.

Se7enLC · **Posted:** Thu Aug 03, 2006 1:50 pm

Jeepjeepster wrote:

Bullet wrote:

I will call Heather because I ordered the Frankenlift with the OME stut assembely. There are Ranchos in the rear tho....better to ask first than wonder later....lol.

Just to give you a heads up bullet. With the OME front struts, it seems to be a bit bouncy when pulling or slowing to a stop. If you are pulling into a parking spot or something and dont take it easy on the brakes, it may get alittle crazy. They ride great on the HW though, much better than the stock shocks.

Oh, I love that!

Sometimes when I'm bored in traffic I like to goose the pedal rhythmically, it makes the whole front end bounce like a lowrider.

Guyute1210 · **Posted:** Thu Aug 03, 2006 2:09 pm

I've done two frankenlifts (an 04 and 05), and we used 2 washers one the top mounts of each side. Each to your own, but if you don't want to bend the mount, use a couple of $0.05 washers. If you don't care, then just tighten them down.

Bullet · **Posted:** Thu Aug 03, 2006 2:58 pm

Can't wait to try the bouncy thingy....hehehe. Ok, so the consensus is to use a couple of washers on the top of the shock mount, otherwise it will bend a little bit. Some don't care about the bend but others would rather use the washers.....is that about right?? Sometimes all of the posts get me confused...heheh

JFortier777 · **Posted:** Fri Aug 04, 2006 12:34 am

Bullet wrote:

Can't wait to try the bouncy thingy....hehehe. Ok, so the consensus is to use a couple of washers on the top of the shock mount, otherwise it will bend a little bit. Some don't care about the bend but others would rather use the washers.....is that about right?? Sometimes all of the posts get me confused...heheh

Yeah, that pretty much it. I'll sum it up again though.

Use washers to secure shock.
or
Bend mount to secure shock.

jpzkj · **Posted:** Fri Aug 04, 2006 11:20 pm

Washer Clarity can be found at :

http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?t=10930

SO EXCITED!!!

Who is online