I reached out to Total Chaos to see if I could spark their interest in building components for the KJ. Their response was
"Thank you for your inquiry with Total Chaos Fabrication Inc. At this point in time we have no plans for developing anything for the Jeep Liberty. However, you never can tell what the future may hold, if we get enough inquiries and interest, things may change."
Send them an email at info@chaosfab.com and start bugging the crap out of them!
Total Chaos Fabrication Inc.
159 North Maple St. Unit # J
Corona, CA 92880
(951) 737-9682 Ph.
(951) 737-9006 Fx.
WWW.CHAOSFAB.COM
To give you an idea of their work, this is their 2005-06 4" Toyota Tacoma/4-Runner Long Travel System (13" of wheel travel). TC is pretty darn thorough.
PARTS INCLUDED:
Upper A-Arms W/ Bushings, Uniballs, & Clips
Lower A-Arms W/ Bushings
Tie-Rod Extensions
Tapered Spindle Sleeves
Braided Stainless Brake Lines D.O.T. Approved
Bolt-on Upper Shock Mounts - Specify Brand
Hardware
Adjustable Limit Straps & Mounts
Plated Upper A-Arm End Washers
Weld-on Bump Stop Spacers
Lower Uniball Conversion
PARTS NOT INCLUDED: (REQUIRED FOR INSTALL)
2.5-8" Travel Coil Over King, Sway A Way, or Fox (Upper shock mounts differ for each shock application.)
Fiberglass Fenders
Extended Tacoma Axles to retain 4WD
OTHER ACCESSORIES:
Lower A-Arm Skid Plates
Dual Shock Hoop for 8" Travel Secondary Shock
All-Pro Off-Road showed no interest at all. They're strictly Toyota.