How can I open/remove the knee panel on the driver side (05 model)? Sorry if this seems too naive, I just don't want to break something by just pulling too hard.

thanks in advance

Just pull, it's clipped in.

_________________
2005 4x4 Sport
Yakima Low Riders
Hidden Hitch
MOPAR tow hooks
RL Skink Step Sliders
Magnaflow
3/4 armored
235/70/16 Grabber AT 2
and a lot of little stuff...

two metal spring clips on the top of the panel. It's hinged on the bottom - so only pull from the top.

_________________
02 Liberty Limited
Silver Outside & Taupe Inside
Heated Seats, Sunroof & Infinity speakers
USA Spec I-Pod adaptor, Mopar Sub, Garmin GPS
Tow Package, Select-Trac
Rock Rails, Tow Hooks

More like yank on that sucker! Mine was tight. I thought I was going to break something when if finally popped loose. Be careful though and dont blame me if something does break.

_________________
It may be that your only purpose in life is to serve as a warning to others.

06 CRD Sport
Built 5/11/06
Jeep Green
Rocklizard diff cover
V6 Airbox

Pull hard. It's hinged on the bottom. If you pulled straight out it will probably pop off altogether, so kind of pull downward and it'll be fine. There is no wire attached to it at all.

_________________
DIRTY KJ :: flickr photostream
"Primitive life is very common and intelligent life is fairly rare ... some would say it has yet to occur on Earth" --- Stephen Hawking

thanks for the tip. I'll give it a try