hooperswish wrote:
Could it be that you are so used to a warn out clutch that a new one is difficult to adjust to? A warn clutch has a release point at the end of the peddle release due to clutch wear, where as a new clutch realeases immediately upon letting the clutch out. Maybe inadvertantly you are (without knowing it) popping the clutch. Just a thought...good luck...
Steve
That is exactly what I was going to suggest. I have had a similar experience to MacAttack when switching from one car to another...not with the Jeep but with others. IME when I go from a old warn clutch to a new tight one I have had a similar experience...just that I have done this several times and now can compensate quickly. I did not have this problem when I went from my 99' Cavalier to the Jeep but I could see how it could happen. I usually shift around 3000...which prob explaing the less than stellar mileage I sometimes get. I try to shift closer to 2500 but I tend to have a heavy foot.
When I drive mine I rarely get back down into 1st gear. I am almost always in 2nd around corners or over speed bumps. The KJ manual has a lot of torque and will not stall in second gear...not even come close...it's a great coaster. If you have it is first gear and are going at low speed you can slowly take your foot off the clutch and crawl...even uphill w/o stalling. When I first started 4-wheeling it was definitely a steeper learning curve when going over a steep obstacle and I stalled it frequently...I still stall it occasionally but much less now. When going down a steep incline in 1st and 4-lo all the other guys in LOST Rockies have their break lights on...I just crawl down as 'I do not need no stinkin' breaks!' Heck, on some downhill inclines I need to shift into 2nd so as not to slow the group down.
John
];')