It is currently Fri Nov 06, 2026 8:07 pm

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 5 posts ] 
Author Message
 Post subject: Geting Code P0161 and coolant leak...Help
PostPosted: Wed Jun 20, 2007 6:52 pm 
Offline
Lifetime Member
Lifetime Member

Joined: Fri Jul 08, 2005 5:05 pm
Posts: 262
Location: IL
Hi all,

Geting the following code on my 03:

P0161 O2 Sensor Heater Circuit Malfunction (Bank 2 Sensor 2)

Any thoughts on how to fix this? I usually have my uncle fix this stuff, but he is swamped with work and I don't want to bother him if I don't have to.

As for the coolant leak, looks like its leaking where the lower radiator hose goes into the engine block. I'm guessing the dealer in NM screwed it up when replacing the coolant. Is there a gasket between the block and the plastic fitting or is it just sealant? Doesn't look like the fitting is cracked on initial investigation. Ordered the lifetime hoses from AllJ that I'll install when I take stuff apart to fix the leak.

Thanks in advance,

_________________
<b>DonC AKA FreeJeep</b>
'03 Freedom Edition
Armored, Locked and Loaded
'67 CJ5 - stockish for now


Top
 Profile  
 
 Post subject: Re: Geting Code P0161 and coolant leak...Help
PostPosted: Wed Jun 20, 2007 10:29 pm 
Offline
LOST Junkie
User avatar

Joined: Sat Dec 16, 2006 10:08 pm
Posts: 633
Location: Franklin Ohio U.S.A.
FreeJeep wrote:
Hi all,

Geting the following code on my 03:

P0161 O2 Sensor Heater Circuit Malfunction (Bank 2 Sensor 2)

Any thoughts on how to fix this? I usually have my uncle fix this stuff, but he is swamped with work and I don't want to bother him if I don't have to.

As for the coolant leak, looks like its leaking where the lower radiator hose goes into the engine block. I'm guessing the dealer in NM screwed it up when replacing the coolant. Is there a gasket between the block and the plastic fitting or is it just sealant? Doesn't look like the fitting is cracked on initial investigation. Ordered the lifetime hoses from AllJ that I'll install when I take stuff apart to fix the leak.

Thanks in advance,


In my experiences with the heated O2 sensors,the heater within the sensor itself is what goes bad.So replacing the sensor,without running a flow chart,seems to be the best bet.We don't have very good luck with aftermarket O2's,so you should consider getting it from the dealer.While your there they can also show or tell you which one is bank 2 sensor 2,and if it's upstream or downstream of the cat. conv.

On your coolant leak,take a second look at the waterpump weep hole,if need be use a mirror to be sure the waterpump is not the culprit.On the sealing of the lower hose connector,the dealer can again advise you of whats needed to seal it.Keep us posted. :wink:

Ron

_________________
Ron
03 Red Libberty Sport
3.7 V6 Auto 4x4
Lifted
Cooper Discover ATRs 265/75/16
American Racing 16x8 Polished Baja Wheels
Moog Lower Ball Joints
Member#051397 L.O.S.T. Midwest


Top
 Profile  
 
 Post subject:
PostPosted: Wed Jun 20, 2007 10:58 pm 
Offline
Lifetime Member
Lifetime Member

Joined: Sat Apr 01, 2006 9:38 pm
Posts: 12988
Location: Colorado Springs
As far as the lower rad hose leak goes,there is a plastic gasket that seals the t-state housing(which is plastic to) to the lower block.Maybe they reused the old gasket,which your not supposed to do,so that may be your culprit for your coolant leak.


Top
 Profile  
 
 Post subject:
PostPosted: Fri Jun 22, 2007 5:24 am 
Offline
LOST Member

Joined: Fri Jul 08, 2005 9:28 pm
Posts: 475
Location: Chesapeake, VA
I just fixed a similar coolant look in the same area. I replaced the thermostat and replaced both upper and lower hoses with the BRX liftetime hoses. That seemed to solve my coolant leak.

_________________
LostRenegade - Lost # 477
2003 Jeep Liberty Renegade - Silver
Mopar Skids, Skid Row Tranny Skid, Boulder Bars, Frankenlift II, 60" Hi-Lift Jack, K&N 6x9 Air Filter, Magnaflow, Dertoit Locker, 245/75R16 BF Goodrich All Terrains, Al's A-Arms


Top
 Profile  
 
 Post subject:
PostPosted: Fri Jun 22, 2007 9:24 am 
Offline
Lifetime Member
Lifetime Member

Joined: Fri Jul 08, 2005 5:05 pm
Posts: 262
Location: IL
LostRenegade wrote:
I just fixed a similar coolant look in the same area. I replaced the thermostat and replaced both upper and lower hoses with the BRX liftetime hoses. That seemed to solve my coolant leak.


Cool, thnx

_________________
<b>DonC AKA FreeJeep</b>
'03 Freedom Edition
Armored, Locked and Loaded
'67 CJ5 - stockish for now


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 5 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 9 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group. Color scheme by ColorizeIt!
Logo by pixeldecals.com