Well, will it? I have a newly installed 2.5 coil from Rustys. Wondering if it will safely support a new bumper without sagging or changing the ride. Anyone have any clues?

_________________
Pre-Lowered 02 Liberty
2.5" Rustys Coil w/ Ranchos in the rear.
ARB, OME927's, 1/4 strut plate and Als Gen 4.5 Uppers in the front.
Flowmaster Super 40 Series (GONE, SO QUIET!)
245/75/16 Kumho KL-78 w/ Spidertraxxxxx
Ripped out the plastic inner wheel liners
Herculined ALLLL over.....

arb winchless ?

i have the arb and it did sag about 1/4" overall.

had to upgrade to ome heavy duty front springs with .75" poly spacer to compensate for the weight of the arb.

rustys front springs will sag if you add a front bumper. go ahead and get the heavy duty's from whereever you would like.

_________________
2004.5 dodge qclb
smarty powered / isspros
2005 sivler lj
http://s303.photobucket.com/albums/nn13 ... ider_2008/

should of bought the heavy Duty OMEs to begin with then no problems! Mine maybe went down an 1/8 of an inch with the bumper

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited

yep, should have, but i wasnt planning on buying a bumper until i got the deal on that arb.

funny how plans change.

i now have a set of heavy duty ome's sitting in the back floor board.
if there is anyone willing to help a fellow texan out on getting these installed, just let me know...

_________________
2004.5 dodge qclb
smarty powered / isspros
2005 sivler lj
http://s303.photobucket.com/albums/nn13 ... ider_2008/

I would like to know how much lift you loose when you put those on jason.. I thought about getting some of those since my MED OME's didnt give enough lift, but I wasnt sure if the HD ome's would give any lift. I gained 1" of lift going from the OME coils to the Rustys coils..

_________________
LOST KJ'S
Where are you going???
Current Jeep: 2004 Jeep Liberty
-Atlantic Blue
-Air Ride Rear Suspension ; OME/Rustys Lift ; Powertrax Locker ; Moog Lower Ball-Joints ; 245/70/16 Yokohama Geolander A/T-S's on MOABS ; Flowmaster 50 SUV
Lost #007082
http://www.cardomain.com/id/jeepjeepster

im putting the .75" poly spacer on along with the hd springs, so it'll basically be a franky in front. springs only, i probably wouldnt gain that much since the rusty's springs have sagged about as much to equal the heighth of the hd's.

just guessing at that, i'll be sure and measure to see what i gain.

_________________
2004.5 dodge qclb
smarty powered / isspros
2005 sivler lj
http://s303.photobucket.com/albums/nn13 ... ider_2008/

The RL front will be fine, it is very light, but we are still in prototype stage and RockLizard would have to say more.

I guess I do too good of a job R&Ding the bumper, because he keeps seeing things that he "needs to change" before the production runs

_________________
I'm baaaaccckkk...
LOST Member 10
If you can read this you don't need glasses, go Wheel your Jeep!