cmohr wrote:
Your a funny man CD, ............a funny man.
Those bump stops of yours working OK????, I made a set out of a Hi density rubber mallet, cut the head away from the handle and cut off each side of the hammer head to make two 40mm high bumpstops, fitted them in the back with you-beaut doublesided tape and no more nails, they worked a treat at Levuka.
Will have the new custom rear coils in this weekend with any luck, I'll let you all know how they go
(I'm a little excited about it)
One of the owners was at out the front on a fork when i was leaving yesterday, so I thought ............. what if....
Bump stop: That's different cmohr, sounds like it worked very well. Mine are 20mm thick polyurethane (I think), there is no compression or give in them at all. Which is good, as 20mm wouldn't be enough if it was rubber. Yes, they work well but could probably be another 5mm thicker.
I will be looking at LOST on Sat night to see if you post any pics of your new springs (Let me know where you post if not Downunder). Do they have a higher rating or longer or...... or...... I will probably have to wait and see what you say on Sat or Sun (if you do the install). It will be great to maintain a good lift in the back while fully loaded. Looking forward to it mate.
Login
Register
FAQ
Search
