I walked up to my crd and saw a tube hanging down. It is connected to the top of the auto trans. I think the trans vent. My question is where is it supposed to run?

That would be the transfer case vent - the trans vent is ~2" long - the xfer case vent hose should follow the transmission harness up to a safe area somewhere beyond the firewall - I "T"eed ours with the trans tube, ran it forward and up, put the trans breather cap on the end - unfortunately, ya gotta have the trans\xfer case assy down to do that

_________________
'05 CRD Limited
Pricol EGT, Boost
GDE Hot '11; EDGE Trail switched
SEGR; Provent; Magnaflow;
Suncoast T\C, Transgo Tow'n'Go switch;
Cummins LP module, Fleetguard filter, Filterminder
2.5" Daystar f, OME r; Ranchos; K80767's, Al's lifted uppers
Rubicons, 2.55 Goodyears
Four in a row really makes it go

Thanks, it's raining today. I'll put it on ramps and see if I can route it in that direction. Is there some kind of keepers?

Dunno - ours was trashed during the F37 recall

_________________
'05 CRD Limited
Pricol EGT, Boost
GDE Hot '11; EDGE Trail switched
SEGR; Provent; Magnaflow;
Suncoast T\C, Transgo Tow'n'Go switch;
Cummins LP module, Fleetguard filter, Filterminder
2.5" Daystar f, OME r; Ranchos; K80767's, Al's lifted uppers
Rubicons, 2.55 Goodyears
Four in a row really makes it go

you can extend them all. I think this thread mentions all of the breathers.
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?t=7229&postdays=0&postorder=asc&highlight=extend+breathers&start=0

_________________
2005 CRD
stuff
Skeptic quod gratis asseritur, gratis negatur

Thanks guys, I'll have a project this weekend.