I need to know if the Daystar or skyjacker bump stops will hit the grease nipple on Al's gen 4 arms? Again ..... please only reply if you absolutly know...

Yes they will.I replaced the angled zerks with the shorter strait ones.It was pretty aparent where the UBJ was touching my SkyJacker bumpstops(from the indentations),I just took my dremal and a engraving bit and made a nice hole in my bumpstops where the zerk hit.Now when my UBJ's hit the bumpstops the zerk goes in the little hole I made in the bumpstops and won't break them off.

EDIT---pics added
Before modding the bumpstop.

After I modded the bumpstop.

great pic's...thanks! dremmel and stubs are on my todo list. since your reading this and you know the set up..... I am replacing the front procomp 3" with the Daystar 2.5 spacer, ome 927, rsx17505, al's arm, moog lower joint..... and instead of lock nuts on the clevis, 2 of rusty's spacers on the top of each strut! what do you think?
shawn

Dont think you can and I would not want to put two of the strut plates on top!

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited

k,i'll leave 'em out. i was just trying to get a 1/2" extra out of it to match the height I have now.I Like the hieght, just not the system.

If you add one top strut plate it will give you more than a half inch

Tom

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited

I have the rusty's 1/2" spacer on top of my strut plate and you will never get another one in there! Plus i have a 3 ring clevis and OME mediums up front.That amount of lift makes me seriously need a set of al's UCA's!
And you could drill out that hole in the bumpstop with a 1/2"+ drill bit if you don't have a dremel tool(one less thing you would have to buy but a dremel will work great if you have one).


* Nice to see someone else here from western canada!




Josh

_________________
**REMEMBER YOU CAN ALWAYS GET A HUMMER IN A JEEP.... YOU CAN'T GET A JEEP IN A HUMMER**
2003 Jeep Liberty(KJ) Renegade,235/75/16 Goodyear Wrangler Silent Armors 245/75/16 MTR's,Factory Skids, Selec-Trac,trac lock,Husky Floor Liners,OME Lift,948 rear/926 front,Rusty's strut plate,clevis 2.5 "s, Al's UCA's Gen 4.5.