Skid plate install

loosvelt · **Posted:** Mon Feb 18, 2008 4:18 am

Hey guys, I am buying Mopar Skid Plates off J parts soon, and was wondering if I, with basic tools and basic car knowledge, could install any of them myself. I want to save as much money as possible. Any of them not require drilling. My 07 did not come with any.

Grape · **Posted:** Mon Feb 18, 2008 9:12 am

They are really easy to do with normal tools. Personally i used a set of ramps and pulled my Liberty up on it and installed them. I know 2 of the skids overlap so make sure to pre-fit them.

jerbacher · **Posted:** Mon Feb 18, 2008 10:07 am

Also, depending on what year your liberty is, you might have to drill one or two new holes for the transmission skid. If its 05 or newer, it will fit perfectly.

Dje Ryu · **Posted:** Mon Feb 18, 2008 10:14 am

He said it's an 07. You'll be surprised at how easily they go on. As mentioned above, the engine and trans skids overlap so don't tighten them down until you get both of those in place.

jerbacher · **Posted:** Mon Feb 18, 2008 10:17 am

Dje Ryu wrote:

He said it's an 07.

that he did! :oops:

Skid plate install

Who is online