WoodysKJ wrote:
MiniDevil wrote:
Thanks guys for the replies. I will probably do as suggested with the Yellow Top Optima and the Mean Green alt.
What do you think about an alternator step up kit? Increases the diameter of the alternator pulley wheel so that it spins faster, therefore producing more charge at idle. Does anyone know where to get a decent one and a new belt with longer length?
I will probably be using most of my wattage at idle.
Again...
That is what the Yellow top is for. Once again the alternator, or as chrysler like to call it now, the Generator
ONLY is allowed to charge when the PCM calls upon it based upon battery temp info from the temp sensor located under the battery in the battery tray. Stepping up the alt/gen pulley might do you no good except empty your wallet faster. The Generator does NOT charge in the way we are used to the older ones charging.
Need a new mind set on this.
Yep and making the alternator spin faster can damage the alternator since it is only ment to spin a certian max rpm and making it spin faster will make it go beyond the safe rpm.It's more common to "underdrive"(make spin slower) the alt,water pump,and PS pump then to "overdrive" any one of them,finding a pully to "overdrive" the alternator will be very hard to come by,at least one that will work with our alternators.The longer belt is no problem but will empty your wallet fast until you find the correct length.
Like I said before unless you are running a winch or a on-board welder you will not need anymore then what the OEM(136amp or 160amp)alternator puts out at idle(80-110amps) or the 160 some amps the Mean Green alternator will put out at idle.