Is replacing the intake manifold cover very complicated?

I need to have a mechanic replace mine, and I'm just wondering how worried I need to be about it being done correctly?

Also while the cover is off should I have anything else done?
Is there a gasket involved?



(By the way don't worry about it breaking on your's. It was my fault......got carried away with a wrench)

_________________
2007 Jeep Liberty Sport
Not Just Red..............Inferno Red !
Automatic, 4WD
Mopar Skids, Tow Hooks

I've seen it on TV with a V-8. The install was pretty easy, it's taking all the crap that is attached to it off that takes up time. Wires, Fuel lines and injectors, throttle body, emission control stuff etc.

_________________
2002 Liberty Limited
2.5" Rusty's Coil Lift + OME 927 springs + 1/4" spacers
265x70 Revos
Warn 4x Floods
ARB bumper
TeraFlex extended front bumpstops
Rock Lizard Skink Super Sliders
Bosch Size 86 battery
Jeepin by Al's 4.5 UC Arms
Kryptonite Differential Cover
JBA Bolt on KJ Tri-Angulated 4 Link

gasket envolved yes.

is it hard no.

_________________
02 Liberty Limited
Silver Outside & Taupe Inside
Heated Seats, Sunroof & Infinity speakers
USA Spec I-Pod adaptor, Mopar Sub, Garmin GPS
Tow Package, Select-Trac
Rock Rails, Tow Hooks

When I have the manifold cover replaced should I have a new gasket put on also?

_________________
2007 Jeep Liberty Sport
Not Just Red..............Inferno Red !
Automatic, 4WD
Mopar Skids, Tow Hooks

Yes