Did a search and saw this question was asked but not answered by anyone. Soooooooo.....

Is mounting hardware needed?

Where exadctly do you install it? (I don't see any cutouts for it)

Any links/help would be appreciated.

Thanks,
Jake

the stacker is mounted in the cargo area behind the little net below the extra power socket

normally the stacker kit comes with a template and some trim to put over the hole you cut out of the rear quarter trim

here is a how to



http://site.justforjeeps.com/guide/82208269.pdf

_________________
http://www.cardomain.com/memberpage/742957
aussie KJ Lost No#150605
3" OME lift + Rancho RS9000xl's front and rear
prototype Airflow snorkel
Magnaflow cat back
265/70R16 Hankook MTRT03 on MOABS baby
4.10's and a truetrac up front
super skinks
coming soon
a myride wireless controller

You'll need a sharp knife and a ruler to cut the trim panel.

_________________
02 Liberty Limited
Silver Outside & Taupe Inside
Heated Seats, Sunroof & Infinity speakers
USA Spec I-Pod adaptor, Mopar Sub, Garmin GPS
Tow Package, Select-Trac
Rock Rails, Tow Hooks

Thanks for the responses and the PDF.

I should receive it in about a week or so and if things go well I'll try to do a How-To on it.

Thanks,
Jake