Im doing some work under my dash connecting up my hitch wiring harness and came upon these groups of wires. Does anybody know what connects to these?

_________________
2005 Liberty 4x4

came across those same plugs in my KJ many many moons ago...never got an answer

_________________
03 Black Freedom Edition.
Full Skids
Self Installed Evic.
Self Installed Auto-dim rear view
Custom light bar.

In the works : Lift kit, courtesy entry lighting, back up lighting and rear seat lighting.

I think the small red and white one is for the under dash courtesty lights. No idea what the larger one is for.

_________________
2012 Jeep Wrangler Rubicon

I'm just confused as to why you are int he dash to install a trailer wiring harness?

You doing a brake controller?

_________________
Jeepless again.

Wheeling an Isuzu Rodeo on 1 tons
and a Stock Chevy Tracker

Actually Im connecting the power wire under the dash instead of running it to the battery. If you look in your engine compartment in the fusebox you should or might have a fuse there (Number 10) named trailer tow. It goes to under the dash then ends at at Wire Harness Disconnect. So I just cut it and spliced it together so I wouldnt have to cut a hole in my firewall.

_________________
2005 Liberty 4x4

I'm asusming you are talking about power for the brake controller?

_________________
Jeepless again.

Wheeling an Isuzu Rodeo on 1 tons
and a Stock Chevy Tracker

Actually no....its the power wire that feeds to the right rear of the jeep. Its the Red wire from the Supplemental Harness that some people have to pick up if they do not have the overhead console.

_________________
2005 Liberty 4x4

Yes, but offroadohio's question is still valid. From what I have read, the only reason you need the supplementary harness (and don't have the EVIC) is if you are putting in a 7-pin trailer tow wiring harness (the 4-pin should not need it), and the only reason that I know of for going with a 7-pin harness is if you are planning on installing a brake controller.

Unless you are doing the wiring for something else...

_________________
Colin
LOST#85291
"Blue Bunny"
04 KJ Sport 3.7L AT 4x4
Steel IFS/DL&DTT/4.10s/Tow Pkg/Mopar-Rusty's-Skid Row skids&sliders/OME struts&springs/Rancho shocks/Terraflex bumpstops/Landy FRH/Gen Steel/Grabber AT2s/Spidertrax/Rockcrusher/Hella/Smittybilt XRC8/Bulldog wiring/NAPA brakes/JBA UCAs&spacers/Deka Intimidator

I probably will be adding a brake controller at a later time but the red wire I belive powers the trailer with power not lights but maybe the trailers acessories or brake. The supplemental harness does come with the blue brake controller wire though. The red wire from the supplemental harnees is not used to connect the brake controller, you have to run a seperate power wire and ground to the brake controller. And your correct the 4 pin does not need the supplemental harness only the 7 pin does.

_________________
2005 Liberty 4x4

supplemental wire is used for powering auxilury lighting and such on the trailer. Say its a pop up camper and you want to run the 12v stuff from the jeep, thats what its for.

As to answer your question as to what those connectors are...

I've never been under the dash fo mine so I'm nto 100% but Id say most likely things for stuff yours doesnt have fromt eh factory, lights of somesort, and thign slike that.

_________________
Jeepless again.

Wheeling an Isuzu Rodeo on 1 tons
and a Stock Chevy Tracker