03 EVIC

mjash · **Posted:** Sun Aug 03, 2008 4:28 am

I installed an EVIC on my 03 Libby. I go through and set all the settings and they will only hold for a day or so. I thinks that when I "Step" through all the info the EVIC resets to the default settings. I ran a self test and it passed. What am I doing wrong. Thanks!

VTNomad · **Posted:** Mon Aug 04, 2008 9:40 am

You may have you power supply running from a source that isn't on constantly.

tjkoen01 · **Posted:** Mon Aug 04, 2008 10:25 am

double post

tjkoen01 · **Posted:** Mon Aug 04, 2008 10:27 am

i have the same situation....been like that for a couple years now. I was never able to figure it out. Even rewired it as suggested above without any luck.

Do me a favor. Open one of the rear passenger doors, get in the driver's seat, shut the driver's door and start. Reach back and shut the rear door....what does the evic say? Mine will still say that a door is open.

mjash · **Posted:** Mon Aug 04, 2008 6:41 pm

tjkoen01 wrote:

i have the same situation....been like that for a couple years now. I was never able to figure it out. Even rewired it as suggested above without any luck.

Do me a favor. Open one of the rear passenger doors, get in the driver's seat, shut the driver's door and start. Reach back and shut the rear door....what does the evic say? Mine will still say that a door is open.

Mine does the same thing. I am wondering if there is a firmware update for th EVIC. Any other ideas? I am going to give DC a call to see if they have ever seen this.

03 EVIC

Who is online