Anybody have a photo of these installed and a place I could order a set online? I found a place yesterday online but can't locate it now. I just got a set of Stainless Steel Steelcraft/Aries but I am not sure if I am going to keep them. I was looking for something with 3 crossbars that line up with the lens seams. These I have now have 4 crossbars and don't line up.

I know I am being anal about this but it's my money.

_________________
Jason
----------

These are the ones I want.

_________________
Tom (& Cody, that's my dog)
02 Black KJ LTD, 6/01
lots of stuff...can always use more



Previous: 95ZJ 92XJ 90XJ 80CJ5

these are the ones I got. I am going to keep them, the wife likes them so I don't have to listen to her whine about me spending the money! I bought these from Jack Mikol on eBay he says they are Aries but all the packaging and paperwork shows Steelcraft. Are they one and the same? His eBay ad also shows a different picture than these so I sent him some pics to use in future ads.

_________________
Jason
----------

Are those metal or plastic?

_________________
The Jeep Family:
2003 KJ Renegade - wife's daily driver
2001 WJ Limited - sister's daily driver
1997 XJ Sport - my daily driver
1995 YJ - the trail rig
1979 CJ5 - dad's toy
1966 M416 - the jeep trailer
1948 CJ2A Willys - my new project

Be careful.... Maine does not allow any kind of cover over either headlights or tail lights I have a set of the plastic "Jeep" ones and the only reason it has passed inspection is because the cross bars align with the seams If I could find a set of stainless steel ones that meet that same criteria, I'd own em!
Check with your local inspection garage before spending too much $$$...

_________________
2005 CRD Limited with Select Trac
Bright Silver Metallic
Factory Skid Plates
Factory Towing
Scorpion Trail Stinger chip
"ORM"
RockFather II 2.5" lift
JBA's UCA
Firestone Discoverer M/T, 245/75R16 tires
Spidertrax 1.25" wheel spacers
Rear Sway Bar removed
Samco Hoses
K&N Filter
Yakima rack
Amsoil.

metal, in fact Stainless Steel. The seams line up where needed. The bottom red isn't even used on our tail lights. not even a bulb in there.

_________________
Jason
----------

Are they held on there pretty good? Looks as if one branch could rip them right off!!?????? Not knocking the bling there but it just looks that way

Tom

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited

2 brackets where the Torx hold the light to the body and 1 bracket on the outside edge that screws from the guard to under one one of the posts that pop into the Jeep.

Oh, and it's definitely bling. When they get ripped off then I will go back to the OEM lights and get a set of Manik guards which seem to be more form fitting than these.

_________________
Jason
----------