jeepkj02 wrote:
ATXKJ wrote:
You can also pull a plug wire – and hold it about ¼” from the plug and listen for the spark jumping the gap (be careful – the spark doesn't jump to you)
Yeah, not fun getting jolted by 20,000 volts of electricity.

Well if it only has 12,000 volts going to the plugs it probally won't start,not enough juice,you need at least 20,000+ in today's modern fuel injection engines.The MSD Blaster 3 coil can put out over 80,000volts,not real fun getting hit by that.
Back to your car,check fuses/relays(mainly for the fuel pump) and check to see if the fuel pump is even turning on.If you have a fuel pressure tester that is the easiest way to test if your getting fuel pressure and the fuel pump is working($30 at most parts stores).If you got fuel pressure then go to spark,there are many ways to test for that,the easiest is to get a curent tester that when pressed against a plug wire will light up when currect passes through the wire($10 at most parts stores).If you have both fuel pressure and spark but it still will not start you may have a bad oil pressure sensor or a possible timing belt problem,or you could have a bad/faulty driver in the PCM and the timing is messed up.