seems simple, but you guys have any suggestions for properly removing my radio antenna cover? I just planned on simply prying the cover off with a little elbow grease, but i wanted to double-check first to see if there are any 'tricks' to getting the antenna cover off easily/cleanly?

_________________
Black '03 Renegade
custom 3"OME MD lift w/strut plates
245/70/16 General Grabber AT2s
Spidertrax 1.25" wheel spacers
K&N Intake, Flowmaster 50 Delta Flow
Al's a-arms gen4.5, Moog LBJs
custom fishing pole roof rack
front hooks & dual hitch receivers

Did you get your cover off? Once you remove the antenna it should just slide off. Mine took a tap of a hammer to loosen it.

_________________
My Rig:
2008 Jeep Wrangler JKU
OME HD lift
35" tires (thus far)
plus a ton of other things. J.E.E.P.

yup..got it no prob thanks

_________________
Black '03 Renegade
custom 3"OME MD lift w/strut plates
245/70/16 General Grabber AT2s
Spidertrax 1.25" wheel spacers
K&N Intake, Flowmaster 50 Delta Flow
Al's a-arms gen4.5, Moog LBJs
custom fishing pole roof rack
front hooks & dual hitch receivers

my antenna is realy loose not the antenna its self but the palastic part on the jeep. how do i fix this?

_________________
06 KJ
HAS
Daystar lift with 02 springs
245 75 16 MTs on Painted Moabs
NEEDS
Skids and Tow Hooks
WANTS
265 75 16s, 4:10s with DTTs, and Frankenlift

I would take off the antenna and check under the cover, perhaps you got some dirt in there or something. Then reinstall it. If it is still doing that take out antenna and check out the plastic piece, perhaps there is a crack in it so it will not bite on. Worst case you could always use some tape and build up the area for the cover. Just some ideas.

_________________
My Rig:
2008 Jeep Wrangler JKU
OME HD lift
35" tires (thus far)
plus a ton of other things. J.E.E.P.

Thanks i will check these tom.

_________________
06 KJ
HAS
Daystar lift with 02 springs
245 75 16 MTs on Painted Moabs
NEEDS
Skids and Tow Hooks
WANTS
265 75 16s, 4:10s with DTTs, and Frankenlift