I saw these plastic chrome wheel skins at a dealer and then found them on Ebay. They actually looked to fit pretty well on the 16" factory rim.
http://cgi.ebay.com/ebaymotors/08-Up-Je ... ccessories
Here was my idea for those wanting black rims. Instead of going to the work and expense of having your factory rims powder coated and then run the risk of them chipping what if you where to take these skins and paint them?
The only trick is to figure out a way to prep them and/or remove the chrome plating off the plastic so you could get a good bond on the cover.
I called the place that sells them to ask if they had them available unplated but they don't.
The benefit would be you wouldn't ruin your rims if you changed your mind later, they would be cheap to replace if they did get damaged and they would look stock.
Any thoughts?
_________________
2008 4X4 Jeep Cherokee Limited, Red Rock, with Skyslider, MyGig, tow package, skid plate package.
Patriot driving lights, roof rack side rails, replaced chrome with black trim and body colored grill. Mopar slush mats and rear cargo mat.
