I want to Line-X my cargo area, I was looking at the tie down points to remove them to get the carpet out and noticed that the tie downs are put in with rivits. Has anybody removed these to bed line there cargo area? I assume I will have to drill out the rivits and then bolt the tie downs back in when I am finished but I just want to confirm. Also does anybody have any pics of this project complete? I want to bed line the back of the seat also, has anybody done this also? Any help will do...

_________________
Life's Tough...It's Even Tougher If You're STUPID
2006 KJ Sport 3.7L 226cid V6 42RLE w/
Clevis Lift, Mopar Underbelly's, Tow Hooks, Tow Hitch, Custom Rock Rails, Debadged
WANTS:
OME Coil Lift, Crager Soft 8's 16x8 4"bs, Custom Roof Rack, Steel Bumpers, Cobra 75X CB w/ Firefly, Lots O Lights, Lockers, Four X Diff Cover, One Bad Jeep

Just man-up and start tearing stuff out!!


Im not sure about bed-lining the back of the seat, though, as I think it is cloth..?

_________________
A Jeep and a couple Fords.


I would wreck Kate Hudson.

I took out one of the tie downs, just drill the rivets and take it out, you have to put it back because the holes can let water or anything else go in.

_________________
Liberty - Cherokee CRD 2004 Silver
Garmin GPS - IPOD
Warn M8000 INSTALLED
Daystar Lift
Rancho 9000X
ARB Rear Locker & OBA
Thule Aero
Santiago-Chile

Also the access door to the fuel filter is back there.

I know somebody posted pics of the carpet out of the back. If I recall, there are also some wire looming that ran under the carpet as well as the fuel access plate (RTVed on). I thought about doing it years ago, but you know how things go.

but yes to get the rivets out use a small drill bit or a dremmel. post pics if you do so we can get an idea.

later,
mike

Mike is right about the wires etc. I had my carpet out once and back in. I thought about line-x also. You would have to go around the gas tank access. I thought about using a very thin sheet of metal to cover the access point, line-x it and stick in place.

Terry

_________________
2011 Ford F-150 XLT 4X4

My fuel pump went so the stealership to pull out the tiedowns and then the carpet. Of course after the job was done they THEN found out they didn't have the rivets! Bottom line, leave access for the tank door / plate / whatever they call it.

_________________
My pics!!
'03 Rennie w/all Tupperware
Custom Roof Basket
Mopar Tubular Brush Guard
Garmin GPS V & Laptop w/Nav software
RAM products laptop mount
Maglite w/mount
Rear cargo bay tool cabinet
AllJs Rear Shelf
Rear receiver
250k miles!
LOST #CR051230

ive torn out all my carpeting to be honest youd be better off buying like a husky liners for the cargo space

_________________
04 KJ sport Patriot Blue
Hella 500's
Tail Light Covers
Mopar Rear Tow Hook
Pathfinder AT's