Anyone have this installed? I just purchased an 09 sport for my wife and the only option my wife wanted that it did not have was heated seats. The dealer offered to have them installed but here is my gripe. The installed called me to discuss the install and said he wants to install the switches on the side of each seat. I think this is stupid and that the controls should be on the dash or on the center console. The installer wanted to argue with me that the seat is the best spot. My reasoning is that the passenger would have to be asked to turn it off when they get out of the car if the driver was going to continue driving so they did not stay on. If the switch was mounted on the dash or center console the driver would have complete control. what are your thoughts?

_________________
2009 Jeep Liberty Sport w/skyslider

He probably wants to put them there since thats where they are from the factory.

Either way, its your Jeep so hes got to put them where you want them..

_________________
LOST KJ'S
Where are you going???
Current Jeep: 2004 Jeep Liberty
-Atlantic Blue
-Air Ride Rear Suspension ; OME/Rustys Lift ; Powertrax Locker ; Moog Lower Ball-Joints ; 245/70/16 Yokohama Geolander A/T-S's on MOABS ; Flowmaster 50 SUV
Lost #007082
http://www.cardomain.com/id/jeepjeepster

I added seat heaters to mine and the switches were added to the sides of the seats. Not sure why you'd want to clutter up the dash or console with heater switches but I didn't feel the need.

_________________
2006 CRD http://www.UtahPowderCoatings.com/ http://www.gorecon.com/ I'm kind of a big deal.
RL rear bumper, ARB front bumper, Mile Marker winch, Power Tank, Skids by Mopar & Skid Row, RL Super Skink Sliders, 235/85R16 MTR, Air Flow Snorkel, DTT, 4.10 gears, Frankenlift II, Katskin leather, JL Audio stereo, Rosen video.

I got the idea when looking at this thread:

http://www.jk-forum.com/showthread.php? ... eat+wiring

I liked the way it looked, but obviously it would take some skill to have it installed and I would hate to have the dash or console crack. If it cant be done it cant be done, I just thought it may be a bit easier to have direct access. Plus on the KK series the switch is on the dash next to the shifter

_________________
2009 Jeep Liberty Sport w/skyslider

JL which brand did you use? are they good to go?

I found these a while back on the net.

http://www.heatedseatkits.com/heatedseatkits/index.html

http://www.checkcorp.com/seat-heater/seat-heaters.asp

_________________
2016 JKU RUBICON

other mods coming soon...

I don't recall the brand but they are all essentially the same thing. Shops that install them are going to stock whatever is cheapest at the time. The ones I have feel like thick cotton towels that were washed with a lot of starch.

I installed them along with my leather kit back in 2007 just in time to be fired and have to go to FL. Now that I am back in the Rockies, I am enjoying them all over again. Before I eat breakfast I run outside and start up the engine and flick the heater to "high".

When I get back into the seat..... Good to go.

_________________
2006 CRD http://www.UtahPowderCoatings.com/ http://www.gorecon.com/ I'm kind of a big deal.
RL rear bumper, ARB front bumper, Mile Marker winch, Power Tank, Skids by Mopar & Skid Row, RL Super Skink Sliders, 235/85R16 MTR, Air Flow Snorkel, DTT, 4.10 gears, Frankenlift II, Katskin leather, JL Audio stereo, Rosen video.