springs and spacers?

surfkj · **Posted:** Thu Apr 09, 2009 11:29 pm

i know i have seen this out there before just not sure where. i have a rustys spacer lift and my stock springs are shot. i meen the front coils are allmost touching coil to coil. i know my struts are fine so i was thinking about getting rustys 2inch springs for some more lift and to help my problem. i dont have too much to spend so thats whay im thinking of going this route. any input is good thanx

Hood297 · **Posted:** Fri Apr 10, 2009 10:38 am

This would work, but they would probably start sagging again, since they are the same spring rate as stock, just longer.

I would look into OME, Im sure you expected that answer, haha.

is it essential to you that you reuse the spacer?

surfkj · **Posted:** Fri Apr 10, 2009 10:59 am

well i dont need too but i do want that little extra boost for the time being. its only for about 6month till i finish gathering sfa stuff im allmost there just need longarms and front coilovers.

jsc7002 · **Posted:** Fri Apr 10, 2009 11:02 am

ya that would work or if your only needing it to last 6 months why not go find some OEM coils again, there are several people on here that still have theirs, I just threw mine away bc I couldnt give them away

surfkj · **Posted:** Fri Apr 10, 2009 12:01 pm

well i want a little more lift for the time being. i am debating on ome heavy duty springs or rustys 2inch springs. dont know what to do

tommudd · **Posted:** Fri Apr 10, 2009 12:05 pm

OME of course plus you can resell them easy if later you go SFA or something
Rustys .....why?

KJ kyle · **Posted:** Fri Apr 10, 2009 12:45 pm

good point tom. if you buy OMEs there is ALWAYS a market for them here on lost. resale would be cake

jsc7002 · **Posted:** Fri Apr 10, 2009 12:49 pm

there is no comparison between Rustys and OME

springs and spacers?

Who is online