Hello all,

I'm in the process of putting the SEGR in (finally) but I've noticed that one of the wire colors doesn't match what is shown on the schematic that came with the SEGR. Specifically, the one to C1-85. The schematic shows a sort of orange color, but after counting multiple times, the one that is most definitely in C1-85 is blue and green. Is it common for them to change colors from time to time? (I have an '06.) All the rest of the wire colors match. C1-84 is brown and yellow, and C1-86 is blue and red.

Just want to make SURE everything is right. Thanks!
--Ben

I remember when reading through the SEGR Install thread I made notes on my wiring install diagram because there where a couple wires that were different colors from 05 vs 06.

I have C1-85 tagged with a note saying it was dark blue and green for the 06 harness.

I have not installed mine yet so I am only going by the notes I took, but this would seem to confirm what you found.

_________________
2006 Liberty CRD Limited

Provent @ 43,000 km
SEGR in progress
SAMCO Sport hoses @ 48500 km
Goodyear Wrangler Duratrac LT225/75R16

Thanks for the reply! Yeah, it must be ok, I finished it off and went for a ride. No CELs, no smoke, no explosions. Yay!