I was wondering, if I bought the speciality tools needed to work on our CRD's would any of you be willing to rent them for a reasonable price? You would have to pay shipping both ways, plus authorize your CC charged for the replacement value. Please be sure to reply to this post as well, that way we know you are a serious CRD owner.

_________________
20 year owner of Libby CRD!
2006 LTD Bright Silver loaded with all the needed mods, CCV intact.
Equipped with HDS thermostat, plenty of heat, faster warm-ups, increased fuel mileage.

..... it reduces memory lapses

Works for Autozone and Advance Auto

_________________
2006 Pearl Green CRD
Magnaflow 2 1/2" Cat Back
KJ Extra Leg Room Brackets, Carter Lift Pump, V6 Airbox, ORM
Fuel cooler, Oil Separator, Progard 7
Gauges EGT Boost Trans Temp Oil Pres, Michelin LXT AT2 245 70 R16
7,000# Draw Tight hitch, PML EX Deep Trans Pan
Centrifuge, SunCoast, Transgo, RAM TCM, InMotion Stage 2
Wife's 99 TDI VW Beetle

It would make alot of sence.

But, sure hope it will be awhile B4 they are needed.

_________________
05 KJ - Lt Khaki CRD Sport - w/GDE Eco, Franky II, Al's 4.5 Arms, JK Rubi Moabs, Silent Armors, Spidertrax Adapters, Rola Basket
05 TJ - Silver RME Auto with some Stuff

Have my own, but thanx for the offer!

_________________
06 LIMITED 100000miles, MAGNAFLOW, HOMEBUILT CCV FILTER, POLAR PAD, 02 AIRBOX, CUMMINS LIFT PUMP, SEGR, PILLAR GAUGE POD, CAT FILTER MONITOR, SPYDER TRAX, ALWAYS A LITTLE TWO STROKE OIL OR BIO, WATER/METH INJECTION

I'm at 83K miles - timing chain replacement is coming up and I hear the specialty tools involved are $250 plus--- A rental source would be dandy even if I "sub" out the work as my diesel specialist knows me well and will give me considerations if I make avail special tools if needed-----

_________________
2006 CRD LTD 2.8L VM Motori turbo,CAC, 100K-new timing belt
ORM-SEGR, Trans cooler, CLIII hitch front/rear, Journey HD controller
Mopar skids,"Stone Soup" rails, KK clevis fork 1" mild lift w/Daystar stops
215x85 LRD BFG Commercial A/T's, Rola Rack, V6 airbox, Fumoto valve
10K winch, B5 Biodiesel (ULSD CP3 lube)
Its a Diesel baby!

I have my own complete set too, all four cases from Miller. Would I rent them out? Uhm, not even with a full deposit. Could you rent them with me attached? Well... I'd have to be presented an offer. Its not that I don't trust anybody here... But none of us know each other from Adam. The reality is someone could give me a "deposit" and consider that as their payment for buying the tools from me... And vanish.

These were hard enough to find in the first place, they aren't leaving me until my CRD does. But when I DO sell them, they will be in as-good-as-new condition. Just like they are now. Seriously, most of the parts have never left the cases - still wrapped in the shipping plastic and tool oil.

Like the Mafia says - Is nothing personal, is just business.