What have you done to your KK lately

Elt31987 · **Posted:** Sun Jan 17, 2010 12:08 pm

Installed an HID Conversion Kit with no worries. Hi/Low both work well. :JEEPIN:

zarinKK · **Posted:** Sun Jan 17, 2010 5:15 pm

Put on some stickers

Jeepin_it_real · **Posted:** Sun Jan 17, 2010 11:57 pm

windsheild officially gave out... have a little crack and today i hit a bump... and it went across the windsheild... thank god i'm covered with glass insurance.... on a side note i'm still having trouble with my HId's... might just say screw it and order new ballasts/harness

E2 · **Posted:** Mon Jan 18, 2010 1:08 am

Cleaned the inside of the jeep today as it was more dirty than the outside!
And can't wait but I will have my lift soon.

Diggerfreek · **Posted:** Mon Jan 18, 2010 2:04 am

Took mine out on a little drive

DirtyKK · **Posted:** Mon Jan 18, 2010 8:51 am

ordered the JBA Adjust-A-Strut Assembly for the front of the KK. :twisted:

this way while i have the front end torn apart to do the a-arms i can do it at the same time, when i upgrade the kit itll be easier on me as the whole front wont have to be disassembled. ill be purchasing skids, sliders, gears and a locker first. then ill purchase the rest of the lift kit and upgrade to 32" or 33" M/Ts. im shooting for having this done before summer.
:BANANA:

Jeepin_it_real · **Posted:** Tue Jan 19, 2010 10:29 pm

so, today i paired my phone with my uconnect, i also hooked the playstation up to the mygig, little NHL 2009 haha, also had my windshield replaced earlier today after the mini crack went across the entire windshield. hmmm thats pretty much it.. on tomorrow agenda is fixing my HID's and fixing the grommet seperatign the engine bay and the interior ( where wires run through)... maybe even adjusting my wires and such...

Elt31987 · **Posted:** Tue Jan 19, 2010 10:55 pm

Jeepin_it_real wrote:

so, today i paired my phone with my uconnect, i also hooked the playstation up to the mygig, little NHL 2009 haha, also had my windshield replaced earlier today after the mini crack went across the entire windshield. hmmm thats pretty much it.. on tomorrow agenda is fixing my HID's and fixing the grommet seperatign the engine bay and the interior ( where wires run through)... maybe even adjusting my wires and such...

So did you figure out what was wrong with the HIDs? Upon further investigation, its the controller that makes the buzzing noise, not my Ballast. But the radio overpowers the noise if the radio is like on 8 which is low, and how often do i use Highs anyway

Jeepin_it_real · **Posted:** Wed Jan 20, 2010 1:08 am

only buzzes when you use your highs?... yeah its the relay connection that buzzes... didnt really solve it but i just got in the capacitors from HIDgate... we'll see how they work!

Jeepin_it_real · **Posted:** Wed Jan 20, 2010 2:18 am

just modded my key fob... i get better range now :-)

Diggerfreek · **Posted:** Wed Jan 20, 2010 3:20 am

Jeepin_it_real wrote:

just modded my key fob... i get better range now :-)

I want pictures :twisted:

Jeepin_it_real · **Posted:** Wed Jan 20, 2010 2:50 pm

Diggerfreek wrote:

Jeepin_it_real wrote:

just modded my key fob... i get better range now :-)

I want pictures :twisted:

i'll have em up tonight for ya digger

Diggerfreek · **Posted:** Wed Jan 20, 2010 4:16 pm

Jeepin_it_real wrote:

Diggerfreek wrote:

Jeepin_it_real wrote:

just modded my key fob... i get better range now :-)

I want pictures :twisted:

i'll have em up tonight for ya digger

Thank you

Jeepin_it_real · **Posted:** Wed Jan 20, 2010 7:26 pm

for digger:

(notice the red wire was added... could have been a bit longer but it does the job... if you want me to explain i can)..

because i promised and havent had time... the grill ( bare with me cause the car is dirty hahaha) :

no sun

in the pic above is the whole for my ram air... hard to see but better seen below

Diggerfreek · **Posted:** Wed Jan 20, 2010 8:09 pm

Bling Bling

Thanks

Scar0 · **Posted:** Thu Jan 21, 2010 3:30 am

I tried adding 2" and then 3" of wire to my key fob. I did not change the battery. I only got about 10' more range on it, if that. But hey, 10' is 10'.
2" wire added.

3" wire added.

Pierocksmysocks · **Posted:** Thu Jan 21, 2010 12:22 pm

Scar0 wrote:

I tried adding 2" and then 3" of wire to my key fob. I did not change the battery. I only got about 10' more range on it, if that. But hey, 10' is 10'.
2" wire added.

3" wire added.

What about the receiver on your vehicle? Actually a better question for me to ask, is there a way to solder a longer pigtail to it to increase the receive power? I haven't dinked much with that on my jeep, so I'm a little unfamiliar with it.

I'm also toying with the idea of doing something like this for a remote starter: http://hackaday.com/2010/01/19/cell-phone-based-car-starter-another-take/

Diggerfreek · **Posted:** Thu Jan 21, 2010 6:32 pm

It's probably best not to play with the WCM :wink:

Jeepin_it_real · **Posted:** Thu Jan 21, 2010 6:51 pm

new battery is needed... it gives a much stronger signal

BrendonR · **Posted:** Thu Jan 21, 2010 6:57 pm

Jeepin_it_real wrote:

for digger:

in the pic above is the whole for my ram air... hard to see but better seen below

Ram Air?

this may have been asked before but....

Da Funk?

What have you done to your KK lately

Who is online