OBD II 4.4 ??

jeremesh · **Posted:** Thu Feb 11, 2010 6:08 pm

Well we got our 50+ inches of snow and when I was taking the liberty out today, once I got up over 30 mph, it started to cut out and would die. I could shift into neutral and start it right back up... it would go for a bit, then cut out again. Now the check engine light is on. I tried to do the codes by holding the odometer reset button and it went through the gauge checks but the only thing it showed after the 999999 was "4.4"

What does that mean?

daspes · **Posted:** Fri Feb 12, 2010 8:37 pm

The reset button doesn't work on all years. Did you try the cycle the key on off method?

seolchan · **Posted:** Fri Feb 12, 2010 9:53 pm

Quick question. Can someone point me to the thread where the instructions on doing the resets and stuff like that are? Thanks in advance.

Joe Romas · **Posted:** Sat Feb 13, 2010 9:52 am

seolchan wrote:

Quick question. Can someone point me to the thread where the instructions on doing the resets and stuff like that are? Thanks in advance.

I know the 06 CRD's originally had the ability but it was removed on one of the early flash of the week that we got

Your signature does not tell us your year or engine :?:

daspes · **Posted:** Sat Feb 13, 2010 10:07 am

It is filed under the Tech section...

viewtopic.php?f=16&t=1714

jeremesh · **Posted:** Sun Feb 14, 2010 8:08 pm

So I got an OBD II reader and had a 300 and 339, replaced the camshaft position sensor and that took care of the problem.

OBD II 4.4 ??

Who is online