Well I got me an evic out of a 01 WJ ltd for $35!
It has a bunch of connectors and two lights I think is what they are.
Can someone tell me which off these connectors I don't need?
And if I don't need them should I just cut them of or leave them on and tape them to the main cord so they aren't flopping around.
Here are the connectors-
1.

2.

3.

4.

5.

6.


Heres the whole harness

_________________
'02 Jeep KJ 4x4- Gone
'92 YJ- lift, swampers, bumpers....yeah, its pretty sweet.
*DISCLAIMER*: I can not be held liable for anything I say on the forums or in real life.
I also can not be held liable for any jeep breakage or life problems caused due to my advice being taken.

Nice leopard-print sheets. . . .

_________________
In this war of lines, so many have been crossed. Where will it all stop?

2006 Deep Beryl Green CRD Sport *SOLD 1/22/12*
Provent, V6 Airbox, Fumoto, Samcos, GDE ECO & TCM Tune, Euro JK TC, Magnaflow Catback
245/70/16 Destination A/T's
Boiler's Radiator Skid Plate
Jeepin' By Al 2.5 inch Adjust-A-Strut Lift, JBA Gen 4.5 UCA's (6/5/10)

_________________
Steve
2018 RAM 1500 Rebel
2003 KJ
Mods:Exterior: Frankenlift + 2 extra rear iso, JBA UCAs, ARB Bumper w/XRC8, Safari Snorkel, 265/75/16 AT, Mopar Skids, Boulderbars, RL Gecko Sport Rack
Interior: Infinity Reference speakers, 12" Alpine Type R Sub, Alpine radio, Gauge Pods (Oil, Volts), Cobra Cb, All J Interior Rack

Yeah, I know my sheets are awesome.
I'm already using the how-to. I got it in and everything now. I found that I only needed one of the connectors so I took the whole thing apart ad took what I needed.
Now I just can't figure out how to splice the wires into the OBD port.

_________________
'02 Jeep KJ 4x4- Gone
'92 YJ- lift, swampers, bumpers....yeah, its pretty sweet.
*DISCLAIMER*: I can not be held liable for anything I say on the forums or in real life.
I also can not be held liable for any jeep breakage or life problems caused due to my advice being taken.