The board moved! Sorry for a truly noob question on my first post:

Burned out left brake light on a 2004 KJ Sport. I don't have a service manual. And I'm mechanically inept. Any takers?

Been a little while since I replace mine. But I remember the hardest part was when it was the on near the rear gate hinge. Other wise just remove the two screws ( I believe) from the light housing located inside the rear gate frame. The whole lense will then come out with a little effort. There are some pressure clips holding it in place. Just pull straight back from the vehicle. Once the lense is off, you'll need to remove the bulb. Grap the round plug where the wires are coming out for the bulb you wish to change and rotate it slightly. It then will pull out. Remove bulb and replace. Put everything back in reverse.

Hope this helps.

_________________
IceColeNH #JC060619
03' Renegade
Al's Arms.
3 inch lift; Rusty's springs all around, Rancho struts + 4 electrical conduit washers up front. Old Man Emu in rear.
Moog K3199 in the lowers
General Grabber AT2 - 245 75 16 "load E on a mawl crawler? You don't need those." tire dealer.
K&N Filter
Silverstar Ultras

Glad ya found us again, welcome back!

_________________
Nanette

03 Freedom with some neat stuff done to it that I learned about here.

Here's my complete write-up, just ignore the part about modifying the socket.

http://www.jeepkj.com/forums/viewtopic.php?t=2760

_________________
2012 Jeep Wrangler Rubicon

Perfect thanks VT! Will pick up a bulb and do it.