Skid plate issues

JeepinMaxx · **Posted:** Sat May 15, 2010 11:26 pm

Took off the skid plates today to re-paint them prior to the spring wheeling season. I think they got beat last year :mrgreen:

The skid was hitting the exhaust and diff in a few places

KJ 119 · **Posted:** Sun May 16, 2010 9:21 am

Roll over it a few times.It'll be good as new.

OK,mabe not good as new,but it'll be straight. :mrgreen:

JL Rockies · **Posted:** Sun May 16, 2010 11:50 am

Must be MOPAR?

InCommando · **Posted:** Sun May 16, 2010 12:01 pm

JL Rockies wrote:

Must be MOPAR?

I hate to burst one of the "JBA sucks because of his beliefs" or " Mopar skids suck" rants you go off on regulalry, but IMHO that does not look look like a Mopar and this is in his sig:

Skid Row belly skidplate

BVCRD · **Posted:** Mon May 24, 2010 4:58 pm

That's not Mopar. Too much metal thickness.

Powerman04 · **Posted:** Mon May 24, 2010 5:01 pm

BVCRD wrote:

That's not Mopar. Too much metal thickness.

If he did have Mopar, I'd hate to see his underside if he managed to do that to a Skidrow. :lol:

BVCRD · **Posted:** Mon May 24, 2010 5:05 pm

Powerman04 wrote:

BVCRD wrote:

That's not Mopar. Too much metal thickness.

If he did have Mopar, I'd hate to see his underside if he managed to do that to a Skidrow. :lol:

I don't have a lift an am always in the rocks out here. Mine as been into the tranny pan bigtime. I just use a BFH and straighten it out until next time. It really only protects my pan from punctures.

Boiler · **Posted:** Mon May 24, 2010 5:17 pm

If your skids bend once or twice, you might consider it a fluke, but if it happens again and again, reinforce it!

Skid plate issues

Who is online