THE OHIO CHAT ROOM!!!

tommudd · **Posted:** Fri Oct 15, 2010 9:52 pm

Thats an awful big and long box for a hitch, look at it again Techman

I should have the KJ back in my hands by 2 or 3 tomorrow afternoon if all goes right, bet it will take off a little faster then!!!! :twisted:

Taking off and using Overdrive is going to be fun again!

kskj · **Posted:** Fri Oct 15, 2010 10:28 pm

Had to guess :lol:

New Cat's and high flow exhaust.

tommudd · **Posted:** Sat Oct 16, 2010 12:14 am

DING DING DING We have a winner , well sort of here's the drivers side so far, already have high flow exhaust.......

JeepinJarhead03 · **Posted:** Sat Oct 16, 2010 12:19 am

that can't be right

where's the rust

ohh.. you just took it out of the packaging? it'll rust up good as new by tomorrow lol

kskj · **Posted:** Sat Oct 16, 2010 12:38 am

What kind did you get Tom? Mine is past Due.

tommudd · **Posted:** Sat Oct 16, 2010 12:40 am

Hope it rusts up so it matches the rest of the exhaust
Maybe rusted enough to match by the time my KJ comes back home..................
I miss it, just went out to the garage and stood there..............so sad

tommudd · **Posted:** Sat Oct 16, 2010 12:44 am

kskj wrote:

What kind did you get Tom? Mine is past Due.

I'm trying a Catco, searched for three days for the best price and finally found it from a place in New York state. I'll wait to post everything after I see if it fits right or not, I know the bends are somewhat different so we'll see. I not I'll be :evil:

Won't know until tomorrow afternoon after my 4.10s are done.

stumpjumper_09 · **Posted:** Sat Oct 16, 2010 12:46 am

tommudd wrote:

kskj wrote:

What kind did you get Tom? Mine is past Due.

I'm trying a Catco, searched for three days for the best price and finally found it from a place in New York state. I'll wait to post everything after I see if it fits right or not, I know the bends are somewhat different so we'll see. I not I'll be :evil:

Won't know until tomorrow afternoon after my 4.10s are done.

Is the catco performance driven or just oe replacement? Looks like a great time for headers. :wink:

JeepinJarhead03 · **Posted:** Sat Oct 16, 2010 12:53 am

headers and Side Pipe ROCKRAILS .. .......

tommudd · **Posted:** Sat Oct 16, 2010 1:08 am

That may just work,.................

JeepinJarhead03 · **Posted:** Sat Oct 16, 2010 1:15 am

would be pretty easy to pull off, route the exhaust to the sides, down and back , exit infront of the rear tires then wrap it with fiberglass, clamshell it with 3" pipe and weld on the brackets

:lol:

stumpjumper_09 · **Posted:** Sat Oct 16, 2010 5:51 pm

stumpjumper_09 wrote:

tommudd wrote:

kskj wrote:

What kind did you get Tom? Mine is past Due.

I'm trying a Catco, searched for three days for the best price and finally found it from a place in New York state. I'll wait to post everything after I see if it fits right or not, I know the bends are somewhat different so we'll see. I not I'll be :evil:

Won't know until tomorrow afternoon after my 4.10s are done.

Is the catco performance driven or just oe replacement? Looks like a great time for headers. :wink:

tommudd · **Posted:** Sat Oct 16, 2010 7:38 pm

stumpjumper_09 wrote:

Is the catco performance driven or just oe replacement? Looks like a great time for headers. :wink:

[/quote]

OE replacement, No use for headers, its fine the way it is and I see no use in headers unless you do some other things as well, which I don't have any intention of doing :wink:

well not until it hits 250,000

tommudd · **Posted:** Sun Oct 17, 2010 8:46 pm

Drove it on and off today breaking in the new gears,
so much difference, better mileage, way more power and no shifting back and forth or running with the OD off all of the time
Parked it for a rest down by the river and waited until it cooled some

BugginKJ · **Joined:** Mon Jul 06, 2009 7:35 pm **Posts:** 4576

I was going to ask you how it all worked out, sounds all is good to go! :JEEPIN:

tommudd · **Posted:** Sun Oct 17, 2010 11:19 pm

Been taking it easy on them, no full on starts yet, but rolling on and off the gas easy running it up to 85 and back down to cruising speed, lots of back roads today and letting them seat in, of course the front is fine, he opened it up and looked it over and everything looked new so it was selaed back up and installed.
5 hours to do the rear gears and install the front diff, so not bad at all

BugginKJ · **Joined:** Mon Jul 06, 2009 7:35 pm **Posts:** 4576

tommudd wrote:

Been taking it easy on them, no full on starts yet, but rolling on and off the gas easy running it up to 85 and back down to cruising speed, lots of back roads today and letting them seat in, of course the front is fine, he opened it up and looked it over and everything looked new so it was selaed back up and installed.
5 hours to do the rear gears and install the front diff, so not bad at all

Crawl over any Wranglers yet? :twisted:

Missing the Mudds Emporium meet and greets

BUT fun (work) has been awesome! :BANANA:

tommudd · **Posted:** Fri Oct 22, 2010 10:28 pm

BugginKJ????

You must be a newbie, used to be a guy around Toledo with that name but haven't heard from him in awhile, think he moved away or bought a mini van for a DD.

BugginKJ · **Joined:** Mon Jul 06, 2009 7:35 pm **Posts:** 4576

tommudd wrote:

BugginKJ????

You must be a newbie, used to be a guy around Toledo with that name but haven't heard from him in awhile, think he moved away or bought a mini van for a DD.

Nope, no minivan dd :twisted:

Just been workin and workin and some more workin! My average work day is just about 15 hours, so not much time left for too much else. I have the day off today and have to fit a ton of stuff into today along with my daughters 15th birthday :shock:

Man I am gettin old, son is almost 21 and well since my daughter has straight A's in school, driving permit is coming soon :shock:

Now if I could only have my 12 year old stay 12 for a while :ROTFL:

tommudd · **Posted:** Sun Oct 24, 2010 10:13 am

Well good luck with all of that!
Keepin the one at 12 the other from not driving you nuts wanting to drive! :ROTFL:

The 21 year old, well just good luck :dizzy:

Oh well some day maybe you'll have time for Larry and I again! :-)r

Oh sold Larry , well took the Mig to Larry, :wink:

he is going to buy it, money from that will go into a welder fund. Said welder will then go into a 5 car garage somewhere around here hopefully :pepper:

Oh suppose to be picking up a 4x6 trailer frame soon ( since I never got the one you had :goink:

) has 14 inch tires, only the frame, will need a little welding done for one upright, but not much. Some new LED lighting, new floor/sides/tailgate/top, be good to go.

THE OHIO CHAT ROOM!!!

Who is online