hey guys i have the 10 sport, i am looking at the front hitch by www.curtmfg.com i am thinking i could use it for a tow hook and a winch mount. but i'm not sure if it has enough ground clearance. anyone have one or a similar one? thanks

i thought about doing the same thing, but i sits really low and would kill ground clearence. my

_________________
3.5in RK lift
245/75/16 firestone destination MT
16in cragar soft 8s
black horse grill guard
2 hella 500s

you could use it to support a winch.?

_________________

2008 Jeep Liberty Sport 4x4 - Blue
Auto Transmission, Selec-Trac II, 245/70/16 Firestone Destination AT Tires,
Factory Skids, Factory Tow Pkg , Front Tow Hooks, Black Aries Running boards,
Tint all around, Factory Engine block heater, WeatherTech Digital Fit Floor Mats, Receiver Hitch Recovery Point,

www.CardinalSafetyTraining.com

ideally yes, but your putting the stress of a winch all on the class III pin holding the winch mount

_________________
08 Revenge- Rock Lizard (Skink Sliders & Gecko Roof Rails), High Clearance Trimmed Front Bumper, Mopar skids, Riddler Diff Cover, JBA (5.5 Arms, 6" rear Springs, Front Adjust-A-Struts), 32" DuraTracs, Superior 4.56's, Front & Rear ARB Lockers, Fastman Throttle Body, AEM Intake, Hypertech Tune, Custom Ram Air, RunCool Louvers

yea i'm not saying it would work but i work at a mach./weld shop and could weld something beefy and see how that worked. being basically my first jeep i'll take offroading slow to start but i dont want the hitch digging in then saying to myself that was a waste of money.