Since we swapped out the UCAs to the Als I have noticed a few things. 1-after it has been sitting for awhile and cooled off, if I turn the wheel while driving I have a kreeking kind of noise. Almost like...a person walking on an old wooden victorian floor, lol.
2-Sometimes, not all that often, while turning the wheel I will feel a thunk under the drivers side floor board. I am trying to remember where exactly...I believe it was under my right foot while I had it on the gas pedel. Has anyone else had this? My first thought was something with the A-Arms but then I thought, perhaps my steering box? A couple weeks ago I had some serious noises coming from the power steering, I was still in the drive way. I popped the hood and the PS Fluid was foaming up. I cleaned it up added more fluid and have not had any issues since. It was the first time I have had that happen and I know it usually means there is a leak somewhere but the ground is dry and so was the engine compartment, other than around the cap form when I took it off, lol.

_________________
My Rig:
2008 Jeep Wrangler JKU
OME HD lift
35" tires (thus far)
plus a ton of other things. J.E.E.P.

Grease a few things....namely sway bar bushings. Even if it isn't them, they are probably in need anyway.

_________________
===
New KJ Gear - Desert Armor Flak

2004 Renegade Light Khaki - 4" JBA Lift - Rock Lizard Products: Komodo Dragon Rear Bumper, Prototype Winch-mount Front Bumper, Super Skink Sliders - All J's Super Tranny Skid II - 31" Firestone Destination AT's on Moab wheels - Cobra 75W CB w/ stock Antenna mod

[b]Retired, US Military

I can't remember for sure but I think your Father ( In Law maybe ) installed them while you were at work right?
Did you ever loosen them with full weight sitting on the ground and retighten ( retorque) them ?

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited

Well once again you were right Tom. Checked the bolts and the drivers side rear bolt was a tad loose. I tightened it down and it is back to normal. Now I have a different issue, lol. Will do a quick search before i post about it. Perhaps someone else has had the same issue.

Thank you Tom!

_________________
My Rig:
2008 Jeep Wrangler JKU
OME HD lift
35" tires (thus far)
plus a ton of other things. J.E.E.P.